PPM 300 Hybrid controller
Contact usThe PPM 300 Hybrid controller variant controls an inverter with a power source, and the inverter breaker.
A DEIF power management system can include several Hybrid controllers which then work together to ensure effective power management. This includes Power Take In (PTI) and Power Take Off (PTO) modes, running on battery power only if needed and available, asymmetric load sharing with configurable constant discharge, and genset start if required.
Each Hybrid controller can control up to four heavy consumers and connect up to three non-essential load groups.
Recommended I/O modules
Slot 1 |
Slot 2 |
Slot 3 |
Slot 4 |
Slot 5 |
Slot 6 |
Slot 7 |
PSM3.1 |
ACM3.1 |
IOM3.1 |
EIM3.1 |
GAM3.1 |
IOM3.1 |
PCM3.1 |
The table shows a 7-slot rack, but the controller is also available with a 4-slot rack. Modules PSM3.1, ACM3.1, and PCM3.1 are mandatory. If you add expansion module racks, each expansion rack must contain a PSM3.2 power supply module but does not need to contain other modules.
For general information about the PPM 300 controller range and its modular architecture, see the PPM 300 main page.
Other PPM 300 variants
Product videos
Products
Installing the display unit (DU 300)
Introduction to the display unit (DU 300)
Introduction to the PPM 300 controller rack
Protection and Power Management (PPM 300)
Unboxing the display unit (DU 300)
Unboxing the PPM 300
Tutorials
Installing the Multi-line 300 controller rack
Cases
Ferry saves 30 % on fuel consumption