Unleash the full potential of your DEIF products
DVC 550This training course is for you who are working with commissioning and troubleshooting of digital voltage controllers (DAVR)
- You will learn to set up and troubleshoot DEIF’s digital voltage regulator DVC 550.
- You will get an introduction to the DVC 550 hardware and the EasyReg PC configuration software.
- You will learn the different modes of the DVC 550 and how to use them, and how to interface to the DVC 550.
Attending the DVC training session presupposes completion of the AGC Service course.
Please note that the training will be conducted in English and that you have to bring a laptop with a LAN port. You will have to install software on your PC, so please check if it requires special permission from your IT-administrator.
Training is a cornerstone to success
With the rapid advances in generator control and the increasingly sophisticated communication between engines themselves, it has become more necessary than ever for operators and service personnel to receive hands-on training.
DEIF commits to providing our customers with the information and resources necessary for the efficient use of our products. To that end, we offer training sessions for you and your associates to help you learn how to use DEIF generator controllers and software appropriately on our simulation equipment around the world. Attending a DEIF training session will enable you to provide your customers with cost-efficient solutions that meet all common requirements.
We believe in learning by doing. Thus our courses involve hands-on training with simulation and emulation equipment in a clean, hazard-free, and controlled environment. Together we will simulate and troubleshoot a wide range of typical fault conditions and also applications based on input from the course participants without risking damage to your plant.
The sessions are carried out in small groups for greater flexibility and more involvement.
|DVC||10/21/2020 - 10/22/2020||Skive, Denmark||EUR 850||Available|